Reply With Quote
Tom you could try contacting these people.
http://marinestore.co.uk/Merchant2/m...-and-pb-valves
Attached details of 1 1/2 inch through hull fitting.
Looking for a Skin Fitting
As luck goes, I have a bit of both good and bad.
Long story short, I need to replace a PO installed gate valve and just happen to have a nice extra 1.5" bronze seacock that will fit perfectly. That's the good luck.
The bad part is that it's threaded BSP (which finally dawned on me as I stewed over why the NPS through hull would only go in a couple of turns before it siezed.)
I therefore need to find a bronze 1.5" BSP-thread skin fitting -- which of course I cannot for the life of me find here in the good old USA.
Can any of you folks in Commonwealth countries offer any advice?
Tom
Tom you could try contacting these people.
http://marinestore.co.uk/Merchant2/m...-and-pb-valves
Attached details of 1 1/2 inch through hull fitting.
Life is something that everyone should try at least once.
S/V Adventure
Bristol Channel Cutter
Posting Permissions